Devil Gundam: Extending Piston Casing [Leg Modification - Part 85]

Hi guys!

Today, I will clean up the other piston casing then do a test fit with leg mechanism. So here are updates on Project Devil Gundam!

Just like yesterday I start with removing the excess pla plates using file and once I get quite close to the original piston casing size I slow down a little bit.

Rinse and repeat using sanding sponge and file until the surface is nice and smooth.

I extended both piston casing 1 cm using 10 rings of pla plates each if these piston casings are too long I can just trim to adjust it later.

However, I will need to test fit a few times before final adjustment of the piston casing's length.

Here is progress test fit with the new extended piston casing that later will be connected to the bottom legs.

I will adjust these piston casings when I finished making the connector between them to the bottom leg. So these are my update on Project Devil Gundam for today.

Tomorrow, I will do a couple of test fits with the bottom leg then start making a connector for the piston casing and the bottom leg. Keep on building! Keep on steeming! Have a nice day!