You are viewing a single comment's thread from:
RE: The 3D printed gridcoin chip - Is nobody watching?
Try to play with the retraction settings in your slicer. Maybe increasing the distance or the speed will reduce your problems with the movements.
The strining might also go away when you reduce the print temperature a few degrees.
I've thought about playing with the temperature but not the retraction settings. I'll keep it in mind. I was kind of done with this. The relief design looks and feels much better. But I can't end this with the error in the design. I have to do a reprint so I'll try and see if I can make improvements. Thanks for the advice!