"Crafting"

• Take a plane page, a rectangular shape.

Fold the upper corner in way, make sure that both the corners when folded; the sideways must touch each other and are equally folded into the middle. Use your hand to hold it and slide your fingers on the edges to force it in this shape.

• First you will hold the top centre of the paper and pull it towards the middle of the page. Just as I have done in the below photo.

After folding, again press it properly so that it adopt the shape which is given to it.

Again same folds as were done in the first steps. It is beauty of crafting because it contains folding in sequential and more times. After numerous folding you will be able to make the required the craft for which you are doing these all steps and finally you will reach there.

Equal the sides of the craft and also make sure that folded parts touch each other in the middle of the page.

Here, you will first fold the middle little outing triangular piece in upward position. You will see the piece in above photo and after folding you will see the next step below.

Now, fold the whole thing in opposite side so that it just looks similar to right angle triangle. This the place from where you will shape the wings of the plane and give 3D look to your plane.

Fold and refold the page in the following manner to create the wings of the plane. These will be helpful in the flight of the plane when given mechanical energy with hand by throwing it in the air.

Open up your plane, it is ready. Give the following shape to the wings; an inclined type of fold which helps in elevating the airplane.

This was my effort to make the craft and hope that reader and designers will love it.

Inviting my friends @mile16 @dexsyluz @alegnita

Thank You