a series of LED lights for motors brake lights

Good morning friend who is in steemit ... !!, Good activity, good luck and hopefully healthy always ... this morning I try to assemble my own LED motor light that I bought from Saturday and last night can only assemble this lamp , and this morning just ready for the post, let friends in steemit know a little about this article, below you can see how it works ... 🌋🌋🌋

---

In accordance with the title this time TP will try to make a led circuit with a simple way. Simple here means making this holder without any solder-soldering, no PCB (board where component), without using multimeter, & tools are also easy to obtain materials, although that does not mean ignore the element of safety.

Ok we start, so the story is likethis..Saturday yesterday TP deliberately intention to stop by to the electronics store, before stop by siapin first note keep writing what you want to buy:

1. Clear red glass ledge = 20 pieces,
2. Resistor 470 ohms = 5 pieces,
3. Resistor 330 ohm = 5 pieces,
4. Resistor 150 ohm = 5 pieces,
5. Resistor 50 ohm = 5 pieces,
6. Resistor 1ohm = 5 pieces.

---

---

---

---

---

---

But from this incident we can take the lesson turns out in arranging lampuled there are also factors that we did not expect, newly purchased goods not necessarily also in good condition, especially the led light. There are also led lights that are more dim than other led when in fact the reason because the led light is flawed. Therefore mending while buying in store first tested with container batre gas lighter earlier. Later on we practice to assemble the led lights well & safely ..

---

good luck with your friends ... !!
followmee @rambeesbd