BASIC GUIDE FOR REPUJADO IN METAL PART 3
Hello steemit community, before continuing with the step-by-step explanation of today, I would like to once again thank SteemitBoard for the reward with which they have honored me, thank you very much.
Today I will talk about the third technique, the acocado, in this technique we must generate a greater volume, than in the technique of ironing on aluminum foil, to achieve this we must have a smooth surface, As I mentioned in the previous publication, I use a sheet folded in two, three or more parts depending on the volume we want to achieve, the more folds the sheet has, the more volume you will have in the metal sheet, you will also need a hard surface to support you and Of course the tools for embossing, such as, scissors, profilers with rounded metal and Teflon.
Acocado technique.
Step 1. Once the design has been transferred to the metal sheet, we begin to give volume with the sfume on the reverse of it, remembering that we should start the work of the center of the flower and then continue with the petals one at a time.
Step 2. Now for the right of it we go over the center of the flower with the metal profilers and the Teflon
Step 3. We continue repeating the steps petal by petal in the same way by reverse and the rights until the last.
Step 4. In the following photograph we can see the difference that exists between the three techniques explained so far, and that we have applied or used in the same flower design.
With this last explanation I hope that you have been able to appreciate, the simplicity, the delicacy and the beauty of the embossing on metal.
Originalworks Guía paso a paso con Técnicas de Repujado. All Rights Reserved.
Original content by @erondon