FREE Download - 3D Printing Failures 2019 Edition

in #print3d • 6 years ago (edited)

Download your copy for FREE now! Expires this Friday 11/30/18: https://amzn.to/2qUhgKY
UK Link: https://amzn.to/2Kxjfha
Germany Link: https://amzn.to/2AqHCbV
From a different country? No problem! Just search "3D Printing Failures" from your local Amazon and find this version to download for free!

Join via Patreon to get your paperback at a discount: http://bit.ly/2xBSDbY

This is the first launch of the book, so if you are having any issues downloading or notice any problems, just let me know in the comments below and I will be sure to get it fixed!

Purchase products I personally have tested and recommend! http://3dprintgeneral.com/

▶️ DTube
▶️ IPFS
#printing3d #free #dtube
6 years ago in #print3d by
$0.03
  • Past Payouts $0.03
  • - Author $0.02
  • - Curators $0.00
9 votes
Reply 3
Sort:  
  • Trending
    • [-]
     6 years ago 

    Thank you !
    I had a quick look yesterday on the Kindle edition. Nice job !

    Few comments:

    • For heatbed temperatures, it will be nice to have a table instead of a list.
      I like the sections where you describe the different settings for different materials. May be I missed it, but it will be nice to have the settings inside a table after/before the descriptions you put for each of them.
    • For the initial layer, I think a section for the initial layer speed and the initial layer temperature (+ extrusion flow) would be useful.
    • Burn out connectors or wires: may be add some informations about wire gauges and number of amps to be safe, add a short paragraph of the possibility of using an external mosfet or external DC SSR (or AC SSR)
    • Extruder Stepper Skipping : there is also the case of the over extrusion (generating also clogs at retractions and/or heat creep)
    • Ghosting: it is possible also to setup acceleration/jerk inside the startup gcode without re-flashing the board
    • Heater malfunctioning: probable typo 12V 30A instead of 12V 30W
    [-]
     6 years ago 

    Thank you for the notes! I am always looking to improve for future editions!

    [-]
     6 years ago 

    Oh shoot on that last typo. Damn I reread this guy like 10 times and knew I would miss a couple things. Gonna see if I can fix it once the downloads die down a bit

    $0.00
      Reply

      Coin Marketplace

      STEEM 0.17
      TRX 0.16
      JST 0.028
      BTC 76338.99
      ETH 2965.83
      USDT 1.00
      SBD 2.62