How to repair rear brake pad on HONDA BEAT motor FI 2012

How are you friends of Stemians all wherever you may be all in the shelter of Allah SWT. This time I want to share how to improve rear brake pad on honda beat FI motor
How to put brake pads honda Beat.

Brake pads that have been used up usually mark the sound nging ngin is very noisy at the brake, it is a sign of the beginning if the brake pad when it is changing, but saara noisy it can also be caused because the dirt into the tromol or brake lining house too many, or it could be a brake pad that has been hardened so that the friction between the campasrem and tromol become slippery that causes the noise in the brake lining of the house during braking, if it has happened signs like that then immediately open your brake lining equipment needed to install brake pads honda Beat

-key T size 12 to remove the exhaust laher

-lock key 14 to remove the exhaust hook bolt

-lock 24 size keys to unlock wheel bolts

how to practice to put brake pads honda Beat

• position the motor on standat two try the motor slightly tilted by using also

standrt side to gap it to easily remove the 12 bolts on the exhaust laher, then release

• after the exhaust washer is released, remove also the hook pengiot hook using the key T 14

• then remove the wheel hook bolts using the 24 o 's key, to remove this

wheel bolt it is difficult to try to use the correct key precision so as not to damage the wheel bolt how to remove the position of the motor on the side standrt then help with the brake lever press back so that the wheels do not come swivel, then loosen it using the key 24 try

handlebar that is rather long to easily remove it

• then take off the brake lining and clean all the dirt can wind up the compressor or wind

in an easy way so that the dust does not fly by washing with water and brush using a toothbrush

• then put the brake pad with the new one

• after all installed, reinstall it as before

check all the bolts that have been installed then set the braking distance.