Glowforge 'Pass-Through' Hack: Tricking the Front Flap of the Glowforge with Magnets to Increase the Capacity
The Glowforge Basic does not have the pass-through feature of the Glowforge Pro but with this magnet hack, you can trick the front flap to think the lid is shut fully, allowing you to "pass-in" larger material than usual.
Glowforge does NOT want you to do this.
- First, obviously, this is going to remove the safety feature that is protecting your eyes.
- Second, you are removing the seal that makes the smoke go out of the vent rather than into your room.
Glowforge Protective Glasses
Take precautions!
Why Trick the Front Flap of Your Glowforge?
This is not a permanent hack, it just involves magnets and some tape. While this means you are not permanently changing your Glowforge, if you find you need to do this a lot, then that would probably mean you need to upgrade to a pro :)
The Glowforge Lid with Sensors Tricked Left and Right
Tricking the flap in this way simply allows you to fit longer pieces of material, or awkward shaped material, onto your bed.
In my case, I had acquired a large amount of off-cut plywood from a friendly guy at one of my makerspaces. I had quickly cut it on the table saw just enough to transport it, but I still needed to reduce the length for it to fit on my Glowforge.
This trick allows you to accept more generosity from materials-having friends!
How to Trick the Glowforge Front Door
Magnets + Tape = Win
- Load the Glowforge UI so you can monitor in the top right of the screen where it says the lid is open. We need that to switch to "scanning" so we know we fooled it.
- Get a couple of cheap magnets. They don't need to be especially strong.
- Move them as shown until the LED lights change - that means it thinks the lid is closing.
- When the screen changes from lid open to scanning, you know you have the right spots either side and can tape down.
- Once you are done needing the front flap open, simply un-tape the magnets and you can close it as usual.
Glowforge with Front Flap Hack (and improvised material stand/Ben)
That's it!
Thank you to Kevin Meinert from the Facebook Glowforge group for alerting me that this was even possible!
Posted from my blog with SteemPress : https://makerhacks.com/glowforge-magnet-passthrough-flap-hack/
Join our Discord Channel to connect with us and nominate your own or somebody else's posts in our review channel.
Help us to reward you for making it ! Join our voting trail or delegate steem power to the community account.
Your post is also presented on the community website www.steemmakers.com where you can find other selected content.
If you like our work, please consider upvoting this comment to support the growth of our community. Thank you.