NEW INNOVATION: SEE HOW TO GENERATE ELECTRICITY WITHOUT FUEL by @johnsamuel

johnsamuel (43)in Actifit • 3 years ago (edited)

Hello All

INTRODUCTION
Innovation and creative works will never end, the new innovation about electricity is amazing, where fuel nor gas will be needed.
In Nigeria, there no patent law so the innovation is already in sights. I would like to bring it to the steemit community to attract the world to benefit, paraventure someone, somewhere may improve on it. It is cost effective and soundless.

THE MATERIAL USED IN PRODUCING THE ELECTRICITY INCLUDES:
Motor coil, Fan belt, Revolving machine, preferably, water pumping machine (surface), change over switch, conductor wire and power source.

here is a water pumping machine

HOW IT WORKS AND THE SETTING;
The motor coil and the surface pump has to be firmly fixed permanently in a position with the fan belt connecting the two whereas, source of power is connected to the change over switch to start the process.

here is the change over switch

The motor coil is known to be converting motive power to electrical power. What is needed here is a power supply to the surface pump that is connected to the motor coil through the fan belt that will spin the motor coil to produce current.

The coil is also connected to the change over on the other side through conductor wire meaning, both sides of the change over switch is having current.

Here, one has to switch over to the current produced through the motor coil then the initial power supply is disconnected whereas the power produced through the motor coil continue as long as 24 hours, 48 hours, etc.

here is the diagrams describing the setting

THE CAPACITY OR THE VOLTAGE:
The capacity or the voltage is determined by the KVA of the motor coil used for the conversion of motion power to electrical power. It is interesting to note that the motor coil can be gotten from an old generator as long as the coil is intact, even the Revolving machine can be a rewind one, what is needed here is to do a little welding work that will fit in the fan belt. There is no need for electrical engineer before setting up.