My Post Week # 13 Steem Plants Contest: Beautiful Orchid Flowers
Hello everyone, this afternoon I will take part in another Steem Plants Contest held by @khopka145 who is part of the Steem-BRU (BY-RU-UA) community. Congratulations from me to the contest winners, for those who haven't been lucky, hopefully focus on what will be done.
On this occasion I will explain how we plant one seed so awek and lots of flowers, namely Orchid Flowers, so ... yesterday I walked along the highway when I arrived at a friend's house, I saw there were several orchids in the yard of his house I asked permission to friends to take photos of ornamental plants in his house.
My friend invited me to see how to plant a good and correct orchid flower and lots of flowers, when I arrived at the backyard of his house, I was amazed to see so many orchid seeds.
This is what my friend did, he took the dried coconut belt and used it to cover the roots of the orchid tree, he said to me again. The benefit is to get better results and more flowers, of course, not only dry coconut belts. We first take the coconut belt and soak it in a bucket that is given water until it sinks, enter the stones so that the coconut belt is completely submerged, if possible we soak the coconut belt for 2 or 3 days so that the juice from the coconut belt is completely gone (brown).
After 2 or 3 days we have soaked our belt, remove it from the water, and we will hit it with a hammer.
well ... after everything is finished, one more step is that the coconut skin can be useful for covering the roots of the orchid and so that it does not become moldy, which can cause the flowers to decrease and even the plants will die.
Here it is, all of our friends, we use the anthracol fungicide drug, its function is so that our plants do not quickly get hit by pests that cause it to be late to develop and what's more dangerous if we don't use this drug on plants, the plants will slowly die. Indeed there are those who plant plants naturally but the results are not satisfactory and again we might buy new seeds and plant them again, I think that will make our work increase and of course we will lose.
How do we use the anthracol fungicide on plants? Take a few spoons and put it in a bucket then give enough water and stir until blended. We don't need to spray this chemical on our flower plants, we just need to soak the coconut skin that we have soaked using plain water and put it in the water that we have given anthracol fungicide, interval 2 The hour may have seeped into the pores of the new coconut skin, we just lift it and we dry it, don't need to be dried in the sun in the wind. Note to friends that this anthracol fungicide is very hard. If we have stirred it with our hands, try to wash the hands thoroughly using soap and one more place to dissolve this anthracol fungicide, if possible, don't use it for anything else specifically for this drug only (dangerous for human health and resulting in death)
Take the part of the coconut skin that is cut in half using scissors or whatever is suitable for cutting.
The results after cutting / scissors are more or less like this
The newly purchased seeds are prepared for wrapping the coconut coolies
Wrap coconut skin on the roots of small orchid flowers
Tie the coconut skin to the roots of the plant using sewing thread or something else, don't tie it too tightly, it will not be good in its development.
shoots that begin to grow and will soon show their flowers
The orchid is very beautiful, it is just a flower but it can decorate this world beautifully, thank you all, hope it will be useful especially for me personally. I admit my lack of knowledge about flowers, and I don't forget to thank Steemit especially @knopla145 and the Steem-BRU community for uniting the world through the Stem Plant Contest. even though we don't know each other. Greetings @yogagayo from Indonesia.
Thank you for visiting and reading this post, your suggestions and comments are very much needed for future developments.