LG dryer roller replacement kits

If you own an LG dryer and are experiencing issues with its drum not spinning smoothly or making unusual noises, it may be time to replace the dryer rollers. The dryer rollers are an essential part of the dryer's drum support system, allowing it to rotate smoothly during operation. Over time, these rollers can wear out or become damaged, resulting in a noisy or inefficient dryer. Replacing the rollers can help restore the dryer's performance and eliminate any bothersome sounds. See https://www.amazon.com/3406107-Replacement-Whirlpool-Kenmore-PartsBroz/dp/B07KPMB4NG

To replace the dryer rollers in an LG dryer, you will typically need the following tools: a screwdriver, pliers, a putty knife, and a replacement roller kit. LG dryer roller replacement kits can be purchased from appliance repair stores or online retailers.

Here's a general step-by-step guide to replacing the dryer rollers in an LG dryer:

Disconnect the dryer from the power source to ensure safety.

Move the dryer away from the wall to create enough working space.

Locate and remove the screws that secure the dryer's top panel. These screws are typically found at the back of the dryer but may vary depending on the model. Once the screws are removed, slide the top panel off and set it aside.

Using a putty knife or a flat-bladed screwdriver, release the spring clips that hold the dryer's front panel in place. Insert the putty knife between the front panel and the top of the dryer to disengage the clips. Carefully tilt the front panel forward and disconnect any wiring harnesses that may be attached.

With the front panel removed, you will have access to the dryer's drum and belt. Take note of the belt's configuration and how it wraps around the drum and motor pulley. If needed, draw a diagram or take a photo to ensure proper reassembly later.

Locate the old dryer rollers, which are typically found at the rear of the dryer's drum. They are usually attached to a bracket or shaft. Use pliers or a screwdriver to release any retaining clips or screws that hold the rollers in place.

Once the old rollers are removed, carefully install the new rollers from the replacement kit into the designated positions. Ensure that they are securely attached and aligned correctly.

While the dryer is disassembled, it's a good idea to inspect the belt for any signs of wear or damage. If necessary, replace the belt with a new one to ensure optimal performance.

Reassemble the dryer by reversing the steps you followed to disassemble it. Make sure the belt is properly positioned around the drum and motor pulley according to the configuration you noted earlier.

Secure the front panel, ensuring that all wiring harnesses are reconnected correctly.

Slide the dryer's top panel back into place and secure it with the screws you removed earlier.

Finally, plug the dryer back into the power source, and test it to ensure that the drum spins smoothly and quietly.

It's important to consult the specific user manual for your LG dryer model, as the disassembly and replacement process may vary slightly. If you are uncomfortable performing the repair yourself, it is recommended to seek assistance from a professional appliance repair technician.