Home made log splitter.

in #diy5 years ago

The splitter was made 100% independently in our workshop.

All elements made on a small lathe TUE-35, only the cone after rolling from steel C45 was put into hardening in a hardening furnace up to 46hrc.

A thread with an 8mm pitch made with a parabola-shaped knife.

Three-phase motor 3.5 kW / 1440 rpm used Gear ratio about 1: 1.8, which gives about 800 rpm on the work item.

The axis of the cone is 12 cm above the table.

Coin Marketplace

STEEM 0.21
TRX 0.07
JST 0.027
BTC 28495.39
ETH 1785.23
USDT 1.00
SBD 2.86