You are viewing a single comment's thread from:
RE: Contest #1- Bottle Art Challenge
can you measure the opening of the bottle? I'm into electronics and I can tell you what you need for it. also on the gold dots a smaller black dot can be nice! grtz
can you measure the opening of the bottle? I'm into electronics and I can tell you what you need for it. also on the gold dots a smaller black dot can be nice! grtz
:) you can put it on the photo and make an entry :) ... the thing with dots is that i tend to overdo it... lol
The top of the bottle is 1 inch across.
Wel I can place some dots on the bottle with photoshop but you will never be able to copy it in real live + you'll only have an example from less then half a bottle ;-)
The top of the bottle is 1 inch... do you mean the hole or the outside diameter. I need the diameter of the opening so I can check what components can go inside. if it's too small you can make a hole in the bottom with a diamond hole saw. However this might be too late because there is always a change that the bottle will break. that would be too bad for your artwork.
Yea... i was worried about it breaking. I had thought about the same thing. But i have fairy lights. I dont want to give them because i need thm and they are hard to come by where i am.
The hole is 1.7 cms
I would prefer it if it was photoshopped since for me visuals are always helpful as an inspiration