You are viewing a single comment's thread from:
RE: 3D printing for Beginners - Anet A8
Thanks, good advise. The only effect I have noticed is warping, so corners go off with too high infill.
Thanks, good advise. The only effect I have noticed is warping, so corners go off with too high infill.
Yea it is definitely increased but warping has quite a few other sources as well. First of all materials...e.g. ABS tend to warp much more then PLA. Then having an heated bed with the right temp is best to prevent warping. Don’t know if a anet a8 has this. And the right bed material also can prevent warping of the edges. my best expierence I made with PEI sheets for a print bed when you print quite a lot of PLA