DIY - Piñata 🦄 - Easy - tutorial with images

🦄 Paperboard

🦄 Crepe paper

🦄 Scissors

🦄Silicon liquid

🦄 Paper or wire tape

🦄 Stapler

🦄 Exact

🦄 Pencil

And get to work:

We proceed to make our chosen figure in the cardboard 2 times. And the strips that will be the thickness of the piñata, which will be used to join the two sides of the piñata.

And we cut.

Remember:
We mark the side and side tab which we will paste from the circles (I made them 2 cm each tab).

We will make cuts to the eyelashes so that they can adapt to the figure of the piñata.

We begin to staple the flange of one of the sides of the piñata, if it takes a lot of weight to place enough staple reinforcement.

With the remaining cardboard we cut some pieces which we will staple in the top part of our piñata to reinforce where we will place the paper or wire tape, which is where we will hold our piñata.

I also reinforced with a piece on top

We opened 4 holes and introduced the tapes, we tied them very well.

We proceed to staple the other side of the piñata

We begin to decorate.
We cut strips of crepe paper the width of the piñata, I put silicone on the edges and began to paste the crepe paper, crumpling it in the following way:

We cut strips to stick on the edge of the piñata. Here you can decorate your taste, (make a braid with crepe paper, cut the ends into a circular shape and paste it in the shape of a flower 🌼), play with your imagination. That's the beauty of the crafts, what you do for sure is fine and you put your personal touch.

Then we cut thinner crepe paper strips, we will make fringe cuts, and we begin to paste from bottom to top.

And in the same way we will stick fringes on the other side of the piñata.

We make the opening to introduce the toys and trinkets with the help of the exact on one side of the piñata.

We decorate our taste. This time I made her ears, eyes and horn with foami, cardboard and tissue paper. You can also print or get a poster with the reason you want.