How to Lower a Car (with the educational image)
There are several methods to use when lowering a car. Whether you prefer the sporty look of a slightly lower stance, or a more dramatic drop in height, learning how to lower a car is a straight-forward process which requires manipulating the vehicle's suspension. We'll show you what it's all about.
Method
1
Edit
For Leaf Springs
Image titled Lower a Car Step 11
Alter your vehicle's leaf springs. Leaf springs consists of thin strips of spring steel banded and bolted together.
Image titled Lower a Car Step 22
Remove the leaf springs from the rear suspension of the vehicle. Take them to a spring shop and have them de-arched, or use a reverse shackle.
Another option is reversing the set up by placing the axle on top of the leaf spring, which is called a flip kit. This can be done by a home mechanic with common hand tools.
Image titled Lower a Car Step 2Bullet1
To get even greater or increased drop, couple the flip kit with lowering blocks. These are available online or from your local auto parts store. They come in differing heights and will enable the vehicle to drop extremely low. They can be installed by a home mechanic. Depending on how low you go, you may have to install a C-notch above your real axle. The purpose of the notch is to give you a greater clearance between your frame and axle.
Image titled Lower a Car Step 2Bullet2
Method
2
Edit
For Coil Springs
1
Manipulate your car's coil springs. Coil springs can be found on a car's front and/or back suspension, and are attached onto the A-frame or the axles.
You can remove the stock coil springs and replace them with shorter springs, or take your springs to a spring shop and have the coils softened and shortened.
Image titled Lower a Car Step 3Bullet1
Image titled Lower a Car Step 42
You can also cut the coils yourself.
Use a grinder, cutting wheel, or torch to cut them.
Start with cutting in quarter- or half-coil-turn increments, because cutting a coil is a permanent action. You may have to install shorter bump stops or cut your stock ones to fit.
Image titled Lower a Car Step 4Bullet2
Method
3
Edit
Replace Springs
Image titled Lower a Car Step 51
Replace the springs and shocks. Trade them out for adjustable airbag units available at a local auto supply store or from an online auto parts seller.
In addition to installing the airbags to replace the springs, this method of lowering your car also requires installation of air lines, an air compressor, air reservoir tank and system activation switch.
This process can be done at home.
If you have rear leaf springs, you will need to get rid of them and replace them with a 4 link setup. This process usually needs a professional fabricator.
Image titled Lower a Car Step 5Bullet2
Method
4
Edit
Hydraulic Cylinders
Image titled Lower a Car Step 61
Replacing your car's springs with hydraulic cylinders. Hydraulics can be installed on 1, 2, 3 or all 4 suspension corners of your car.
Installing a hydraulic system also requires installing an internal control system, hydraulic pumps and batteries to operate the pumps.
Image titled Lower a Car Step 6Bullet1
One drawback to this method of lowering your vehicle is the large amount of battery power required to operate each hydraulic pump in the system.
Image titled Lower a Car Step 6Bullet2
Method
5
Edit
Lower the Torsion Bar
Image titled Lower a Car Step 71
Adjust your car's torsion bars down using the torsion bar key.
This will sag your vehicle so it is lower to the ground.
Image titled Lower a Car Step 7Bullet1
Torsion bars come factory equipped on vehicles and consists of a spring steel bar that's used in place of a coil or leaf spring. The torsion bar key is part of the torsion bar, which allows the vehicle ride height to be adjusted at the factory when the vehicle is built and as needed afterward.
It's easily adjusted with a small hand wrench at home.
UpVote, ReSteem & 