The Table from Particle Board Made by Your Own Hands

Hello. Today I'll show you how to make a fairly simple table. If you have a mortgage, like me, necessary count your money :) Therefore, I'm always looking for where to save it... Let's go!

The choice fell on particle board for several reasons.

• In my city a lot of firms that are engaged in saw cut of particle board (not wood).
• A huge variety of colors.

And so, I made an all calculations and ordered sawing of particle board. Also bought konfirmats, special drill for them, rails for drawers, handles and two corner clamps. Plywood was acquired for the bottoms, thickness 5mm.

Assembly itself is not very complicated, but it requires precision and accuracy.

• Assembly of the drawers for nightstands.

• Then cut the plywood to size and fasten bottom by a small nails.

• Rails. You need to take it apart, before installation.

• Accuracy is very important here too.

Almost completed nightstand. it's assembling similar to the drawers. There are two at the sides of the table.

General view of the table. Without it, life was very inconvenient :) Monitors stood on the chairs... well, that flat is very small and the bed is practically close to chairs. It was possible to sit on bed and work on the computer.

P.S. Upholstery on the chairs, we are also changed by ourselves, a couple of years ago. We bought a foam rubber and faux leather. All the work took about two or three hours.

Old photos from a rented apartment.

I wish you success in everything! Do not be afraid to take on any work, the main thing - to undertake any work with the mind!

---

Sincerely, TerryCraft.