You are viewing a single comment's thread from:
RE: Are You Sure You Want To Keep That?
I have the furnace for the investment casting, but still need to buy the ceramic coating material. I made molds for the wax for investment casting when I was in college (I worked at a machine shop)
I do everything with cars. My Land rover is being repaired because the alternator bearings locked up. I had new bearings put in, and I am putting it back in the car right now. I just replaced a U joint, and the drive shaft has to go back in. I am moving the temperature sending unit in my Saturn Ion, to correct a design flaw. And I have a Mercedes 280i in the driveway that has injector problems. :(
hahaha! that is not funny but man you are funny because is there anything that you don't know or do? haha. well sir, the reason I asked is because we have a Jeep Compass and used it like crazy while we were in Ohio for all the snow in the winters.
But with all the salt on the roads up there, the bottom of the vehicle is all rusted, very rough. There is a leak in the oil pan and it slowly drips out oil
but the shop guys told us that since the bolts that hold the pan on have rusted off heads, they can't replace the oil pan.
do you know of any way to get those bolts out? I'm assuming they'd have to be drilled out?
You will need to drill the center of each bolt, and use an easy out. If you drill with a left hand drill bit, about half will come out before the extractor is used, with just the drill bit. Be sure to keep dust out of the open motor, be ready to re-close it ASAP! You can save cash by getting the parts from www.rockauto.com ahead of time.
If you paint the bottom with rust converting primer (PROTECT YOUR LUNGS FROM THE FUMES!) you can spray on a good undercoat, after it dries. The converting primer stops the rust from causing further damage, and helps the undercoating stick.
thank you sir, this is great information!
Debbie always says I am full of...it.
The reverse twist drill will be the hardest to find. I keep a few in my tool box by the mill.
I used a gas mask the last time I used that converting primer, the fumes Will damage the lungs.
smithlabs! howdy today...well if I can't find one I'll just have to come up and borrow yours.
Debbie is very wise. how is she doing?
I shoot prowlers, LOL! :)
Sleeping right now, good to have her home! The dogs went nuts when she got home; Lilly layed up against her all day long.
♡♡♡♡♡