Make your own mobile charger !

Hello Friends,

There is a lot of problems while mobile charging mobile in today's fast life. Nowadays mobile is used so much that its battery has to be repeatedly charged. Now many times, we also face the problem of electric power, which can be impossible to charge the phone. To get you out of this difficult situation, we tell you about a portable charger that you will be able to make yourself. The special thing about this charger is that the charger does not even need electricity to charge the mobile.

Required parts

To create this portable charger, the list of the parts you will need is as follows:

• 1. USB Fiber Connector
• 1. Voltage Regulator IC - 7805
• 1. 5mm Red LED
• 1. 404 ohms register
• 1. 9 Volt Baitry & Connector
• 1. 2 bottle lid
• You will also need glue, shouldardring iron, 3 small wire and wire cutter to paste all these parts together.

How to make such a charger

To make a charger, first take a lid of the bottle and make a big hole in the warm soaring iron. The holes should be large enough to fit the female connectivity comfortably. Put the connector outside and pin inside the lid, fit it in the lid and then paste it well with glue. Now take two small cut wires in which one wire must be black and one red. Connect the red wire to the shoulder ring iron pin 1 and the black wire with pin 4. Now take the bottle's other lid and make it a hole in the shouldarding iron too. After this take the connector and insert both the wire attached in it from the lid hole to the inside. Now take the voltage regulator IC. Cut off its pin and add a wire connector from the shoulderling iron to the first pin of the regulator IC and connect the other wire with another pin.

Usage of the Female Connector Repeat

Now connect the black wire attached to the USB Female Connector to the black wire connected to the regulator IC. After this add the red wire connected to the USB Female Connector to the third pin of the Regulator IC. Use soldering iron to carry out this work. After following these steps you will get the use of 407 Ohms Register. Cut off its wire from both sides and cut it off. Next, add one wire to the first PIN of the regulator IC (which connects the red wire to the connector) and add the other wire to one wire of the red LED. After that you should use another black wire and connect one end of it to the red LED and the other with the pin between the IC.

Stick with everyone

Now tighten all the connections you have made with Glue's help. You paste the voltage regulator IC glue from the glue inside the lid. Make a red LED fit by making a small hole from the shoulderling iron in a lid. After this, paste both the lid together and then paste the connector over the lid. FINALY Now you have a 9 volt battery and USB. Connect this USB to your mobile phone and to a USB Female connect and then connect the 9 volt battery to the connector sticking to the lid. By firing some such steps, you will be able to charge your phone easily. You can take this charger anywhere and charge your phone without the use of electricity.

Thanks for your support, you have been wonderful, @mike11