It's a much simpler process than when the video card is supposed to be overclocked (overclocking). But making some small mistakes is a must. Drivers that are used especially if they are used for mining are very important. I'll try to explain it as simple as my hand.

Required programs

First we need a few basic programs.

1. DDU "Display Driver Uninstaller"

2. Polaris Bios Editor

3. Atiflash

4. Atikmdag-patcher

5. Msi After Burner 16.0.1

6. GPU-Z

7. AMD Radeon Blockchain Compute Crimson Relive Graphics Driver

After downloading all the programs I listed above, we go to ROM. If all the cards are stuck on the rig, you have to remove all of them. Otherwise, there is a possibility of trouble when loading the ROM.

let's start

Plug the display card into the system and open GPU-Z

If Samsung or Hynix do not write in the "Memory Type" section, it is likely that the modeling process will fail.

Under Logon in the upper right corner, click on the logo in the frame and save the .rom file with the name of the card. "Copy this file and do not lose it. You always need to keep a copy. "

Open Polaris Bios Editor Program.

Press the OPEN button in the top left corner and open the file with the .rom extension you just saved.

TIMING (MHz) in the lower right corner;

Copy the 1250 Mhz for RX470 and RX570 to all frequency values ​​after 1250.

For RX480 and RX580, do the same after 1375 MHz.

Save by pressing the "Save" button. "When recording you can specify the name of the card and the mode is to not interfere."

Paste the downloaded AtiFlash into "My Computer> Local Disk (C :)".

Run ATIWinflash as an administrator by right clicking on it.

ROM Details, select the .rom file that you made the mod and load it by pressing the program button and then reboot.

Now do the same for your other cards.

Install the video card driver that you downloaded after all the cards were modded. If you try to drive with a driver other than the driver I share above, you will not see your cards.

Turn on Atikmdag prgromun and press Yes button.

Restart the computer and open the Mining program.

Open the Msi After burner program I shared above.

Set the Power Limit -15, Core Clock 1100 and Memory Clock 1850 for the RX470

I shared the frequency values ​​of the two most preferred cards for the Ethereum mining