Designing exciting and push pneumatic drives.
I will explain what is pneumatic:
Pneumatics ie the theoretical branch of fluid flow or mechanics includes not only the study of airflow through a channel air flow system consisting of pipes, hoses and others as its.
Tools I use:
*Air compressor.
Air compressor that works with the principle of flow generates air to the side and compresses it with air acceleration.
Katub 5/2.
To regulate or control the direction of air which will work to move the actuator in other words this valve works to control the direction of pneumatic valve actuator movement in the name given by: 1) Number of holes.
2) number of work positions.
3) valve actuation type.
- Pneumatic hose.
Hose? Clear plastic hose for me to use for wind channel switch from kompreor to pneumatic valve that will in motion.
- Cylinder two-step valve push and pull.
Two step valve cylinder here I also can mean the cylinder is able to give power and able to move in two directions with elongated and abbreviated. Air is passed through the end of the cover to extend on the cylinder cover and the end of the rod rod is released to the reservoir.
- Steering Valves (Directional Control Valves)
Valve valve 3/2 Way valve (WV), inverting spring (3/2
Plaser DCV driven, centralized spring), including the type of disk valve (discs
Valves) are usually closed (NC).
- Roller lever 3/2
Roller lever 3/2 plunger springs rear moving pistons (4/2 DCV plunger driven spring centered) including disc type valves.
*Mounting pneumatic pushing and pulling on the table that I will plug.
After everything has been ready for his tools, next langkag installation that I will put on the pneumatic table that I will do.
After all I have done step pairs This is the result I have compiled on the pneumatic circuit in the cutting action of the object and pulled it after cutting the pieces I did in the pneumatic laboratory at my school with lhokseumawe courtesy with my own hands, dated 18-tues - 2017 o'clock 02.15 noon.smoga can be useful for friends in Steemit.
